BIOAQUA is a microbiological product base on a mixture of selectively adapted bacteria, which accelerates the decomposition of organic matter, the degradation of wastes, consumes excessive nutrients and sediments at the bottom of lakes. BIOAQUA prevents and controls excess algae or an algae bloom at Municipal lakes or public fountains. BIOAQUA acts as a highly efficient probiotic that competes with a wide range of aquatic pathogenic and diseases. BIOAQUA prevents and diminishes the eutrophication effect by competing, for food, with algae that receive nutrition form fish waste, over feeding fish, decaying organic matter (leaves & plants), lawn fertilizers.
By Atlas Seis - Sistemas de Energia para a Industria e Serviços, Lda. based in S.Domingos de Rana, PORTUGAL.
Given the large areas and relatively shallow soil depths associated with agriculture, the industry standard has long been two-dimensional analysis. However, over the past decades many of C Tech’s customers have discovered the advantages of analyzing and understanding soil properties on a true 3D volumetric basis. Nutrient concentrations, plant available water and stratigraphy are examples of data which are best addressed on a volumetric basis.
By C Tech Development Corporation based in Henderson, NEVADA (USA).
Measuring Ion Concentrations in Plant Tissue
- Aptisens Digital or Mobile Multiple Ion Kit
- Weighing scales
- Liquid measurement device e.g. graduated cylinder
- Bowl for stirring
- Spoon for stirring
- Filter paper / muslin
- Conical flask / vessel
- Aptisens multiple ion conditioning solution
- Aptisens Plant Tissue multiple ion calibration solutions
- Deionised water
This preparation can be applied to any plant tissue. Take a sample of lettuce and remove any soil but do not wash the plant tissue as doing so may reduce the number of ions in sample. Weigh this sample and record (say 100 g). Macerate the plant tissue in a blender and add a known amount of hot deionised water to the sample to extract the nutrients. For example, dilute the sample two-fold (200 mL), three-fold (300 mL) or five-fold (500 mL). Ensure all the plant tissue is covered with water and leave to sit for approximately 30 min with some stirring. The sample then needs to be filtered.
Set up a funnel with folded filter paper in a conical flask or any vessel that can hold a funnel. Pour the plant tissue and water into the funnel and allow the mixture to filter. Collect the filtrate.
Before use the multiple ion probe must be conditioned in Aptisens multiple ion conditioning solution. Ensure the correct calibration solutions for a three-point calibration are set up on the Mobile meter or MeterLink. Follow the instructions for calibration and proceed to take a sample reading when the calibration data is ‘very good’ or ‘good’ for all ions.
Place the probe in the plant tissue filtrate and ‘Take a Sample’ reading. The concentrations for each ion will be displayed in ppm or mmol / L.
Remember to multiply these concentrations by the dilution factor.
After taking your reading be sure to remove the sensors from the solution as quickly as possible, rinse with deionised water and replace the cap of the probe
By Aptisens based in Little Island, IRELAND.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you