Irrigation Equipment In Uganda
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture sensor Thetaprobe ML3. Measuring range 0-50% vol. Accuracy +/- 1%. With 4 pins, length 60 mm, Ø 3.2 mm. Output signal 0-1 Vdc. Inclusive temperature meter range -20...+60 °C, accuracy +/- 0.5 °C over 0...40 °C. Exclusive cable. Warranty 5 ...
-
based in UGANDA
this is a very good product . Flow rate :14.4m3/hr maximum radius of cover :42m pressure requirement ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Also included in our product range is the WET sensor, to measure pore water conductivity and temperature in the top layer of a soil. The measurement values are shown on the display of the hand held meter and can be stored in the memory (including time and sensor location). These data can be read on a ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture sensors that measure the moisture tension in the soil are read out with the soil moisture meter Watermark. The measuring principle is similar to that of the gypsum block system. The special sensors however do not dissolve in the soil and have a more consistent distribution of pores so that more accurate measurements are ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Tensiometer set. Complete standard set for multiple measurements to a depth of 90 ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
EC-probe for soil salinity measurements, standard set for measurements to 1 m ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Set for pF determination with ceramic plates, minimal standard set, (0.1...15 bars of ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The Jet-fill tensiometer basically has the same components as the standard tensiometer but is equipped with a reservoir and a refill mechanism. At a push of the button the Jet-fill mechanism instantly injects water from the reservoir into the body of the tensiometer and removes accumulated air. This tensiometer can be provided in different lengths as ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The standard tensiometer consists of a clear transparent plastic tube with a ceramic cup at the bottom end and a manometer at the top. The standard tensiometer is delivered in various lengths allowing the execution of simultaneous measurements at various depths in the root zone. For pre-drilling special auger sets can be ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The quick draw tensiometer is a small tensiometer that can easily be moved and, using the auger for pre-drilling, placed into the soil. The small diameter and the super porous ceramic cup and the possibility of pre-setting the tension, allow a measuring period of only a few minutes. After each measurement the tensiometer can be stored in a carrier cylinder in which it is kept humid allowing ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you