ASTM International

ASTM A664 - 11 standard practice for identification of standard electrical steel grades in astm specifications


Source: ASTM International

This practice explains the procedure for identifying standard grades and types of flat-rolled electrical steels in ASTM electrical steel specifications. This practice applies to flat-rolled magnetically soft irons and steel such as low-carbon steels and alloys of iron with silicon, aluminum, and so forth produced to a specified thickness and maximum value of core loss. These designations are intended to replace the old AISI M designations which are no longer supported. The practice also has a cross-reference between thickness and electrical sheet gage number.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This practice covers the procedure for designating (within ASTM specifications) standard grades of flat-rolled electrical steels made to specified maximum values of core loss. This practice applies to magnetically soft irons and steel (low-carbon steels and alloys of iron with silicon, aluminum, and so forth) where a core loss measurement at a stated peak value of alternating induction and a stated frequency, such as 15 kG (1.5 T) and 60 Hz, is normally used to grade the material. This practice also applies when some other property is specified (or a different induction or frequency, or both) as the limiting characteristic, provided the material also meets all the requirements of the ASTM specification.

1.2 Individual specifications that are in conformity with this practice are Specifications A677, A683, A726, and A876.

1.3 The values stated in customary (cgs-emu and inch-pound) units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
A340 Terminology of Symbols and Definitions Relating to Magnetic Testing
A677 Specification for Nonoriented Electrical Steel Fully Processed Types
A683 Specification for Nonoriented Electrical Steel, Semiprocessed Types
A726 Specification for Cold-Rolled Magnetic Lamination Quality Steel, Semiprocessed Types
A840/A840M Specification for Fully Processed Magnetic Lamination Steel
A876 Specification for Flat-Rolled, Grain-Oriented, Silicon-Iron, Electrical Steel, Fully Processed Types
A976 Classification of Insulating Coatings for Electrical Steels by Composition, Relative Insulating Ability and Application

Index Terms

core loss; electrical steel; fully processed; grain-oriented electrical steel; identification; laser scribed; magnetic lamination steel; nonoriented electrical steel; semiprocessed; ASTM voluntary consensus standards; Core loss; Current measurement; Electrical conductors; Electrical grades; Electrical insulating materials--specifications; Electrical steel; Iron; Iron (magnetically soft); Magnetic alloys (soft); Magnetic materials/applications--specifications

ICS Code

DOI: 10.1520/A0664-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM A664 - 11 standard practice for identification of standard electrical steel grades in astm specifications. Be the first to comment!