eFACTOR3 LLC

HOT! HOT! HOT! Performance Cutters - D2 & Carbide Tipped

0

Source: eFACTOR3 LLC

Here's just a sampling of what we carry:
• 30x30x19 • 40x40x20 • 40x40x23 • 60x60x30

STANDARD CUTTER
Edges will round rather quickly on Standard D2 type cutters and need to be rotated more often. Rotation approximately every 40 hours of production.
If the Standard D2 type cutter is the preferred solution for your particular application, we have what you're looking for.

CARBIDE TIPPED CUTTER, old version
Old Design with gap between carbide inserts. Reduced life but still 6-8 times longer than standard cutters commonly used. First rotation required after approximately 300 hours of production due to washed out areas between carbide edges even though carbide is still sharp. As we transition toward the new Carbide Tipped Cutters (featured below), old versions of the Carbide Tipped Cutters will no longer be stocked or available once inventory is depleted. Call today for INVENTORY DISCOUNTS!

CARBIDE TIPPED CUTTER, new eFACTOR3 version (image left)
NEW DESIGN, NO GAP BETWEEN CARBIDE INSERTS, LONGER LIFE
On the New Carbide Tipped Cutter, the carbide inserts are installed without a gap. Your first rotation is suggested at around 400 hours of production.

Learn more about WEAR and SPARE PARTS available from eFACTOR3 HERE.

Download a copy of the latest brochure insert HERE.

HOT! HOT! HOT! Performance Cutters - D2 & Carbide Tipped

Customer comments

No comments were found for HOT! HOT! HOT! Performance Cutters - D2 & Carbide Tipped. Be the first to comment!