- Model M8D - Brush Chipper

From

0

Perfect for rental yards, landscapers, golf courses and pruning crews, the high-capacity Beever M8D Brush Chipper is easy to transport and operate. Plus, it’s the only chipper in its class to combine both a wide infeed chute opening and 1 1/4″ thick chipping disc for a greater chipping capacity than comparable models. The M8D has a 251-pound disc and shaft weight, which provides more inertia to power through material and continuously feed material. With a single top feed wheel compression system and 32.3 ci hydraulic motor with spring-assisted down pressure, the M8D generates more than 2,300 lb./ft. of material pulling force and approximately 1,000 lb./ft. of combined down pressure to easily feed a variety of materials. Like all Morbark equipment, the M8D is a long-lasting, durable machine backed by a world-class parts and service support team.

Belt Drive
Direct drive with belt power transfer eliminates clutch components and over center belt tensioning systems, reducing problem areas and easing maintenance burdens.

Infeed Chute
Infeed chute with 96-square-inch throat opening allows for easy material feeding and reduced trim labor and folds to reduce transport and storage length.

360° Swivel Discharge
360° swivel discharge with adjustable chip deflector puts chips right where they’re needed without removing the Beever from the tow vehicle.

Feed System
A top feed wheel compression system with spring-assisted down pressure easily breaks down a variety of materials.

General

Chipping Capacity: 8″

Height: 7’4″
Width: 5’3″
Length (transport) : 11’10”
Length (operating): 13’8 1/8″

Gross weight (approximate): 2,700 lbs.

Suspension: 2,200 lb. torsion

Infeed opening: 33 ½” wide x 24 ¼” high
Throat opening: 12″ wide x 8″ high
Feed wheel: 11 ½” wide x 9″ diameter
Disc dimensions: 1 ¼” thick x 28″ diameter

Engine: Kohler or Kubota

Horsepower: 35–44 HP

Fuel capacity (tank): 10 gallons
Hydraulic oil capacity: 10 gallons

Frame: 2″ x 4″ Tubular

Tires:  (2) 185/80Rx14″

Hitch: 2″ Ball

Equipment Highlights

Direct drive with belt power transfer

Automatic feed system

Chipper disc with two 10 ½” x 4″ x 3/8″ dual‑edged chipper knives and four full-length, bolt-on, chip throwing paddles

Reversible feed works control bar and dual safety cables located within infeed chute

Pinned chipper hood access with integrated hood safety device to disconnect the start system when the chipper hood is opened and allow ease of disc maintenance.

3″ x 4″ tubular steel fixed length drawbar and 3/8″ thick safety chains with clasp hooks

Morthane Paint System: A chemically cured, electrostatically applied urethane coating with high-gloss finish, built-in UV protection, chip and chemical resistance and corrosion protection

Fuel tank sight gauge, drain plug and shut‑off valve

Hydraulic tank shut-off valve, drain plug, clean-out cover and vented filter head assembly with dipstick to check oil level

8D, 1400 CCA Battery

Options
  • ChipSafe® Operator Safety Shield
  • Variable speed flow control
  • 2,500 lb. Torflex suspension axle with electric brake system, electric brake actuator and 185R14 tires with rims
  • Custom paint and logo packages
  • 2 ½” lunet ring
  • Knife saver tool
  • Engine stop on infeed
  • Material pushing tool
  • Spanish and English safety decals

Customer reviews

No reviews were found for Beever - Model M8D - Brush Chipper. Be the first to review!