Model 14.01 - EC-Probe for Soil Salinity Measurements

From

0

In irrigation areas, one is often confronted with salinization problems. In order to acquire the necessary understanding regarding these issues, it is very important to check the salinity of the soil regularly. Also in examining ecosystems that are influenced by salt water (lagoons, etc), it is necessary that we know the salinity of the soil. In some countries, salinization problems can occur in road shoulders, as a consequence of salt sprinkling in the winter.

Determination of the soil salinity is possible by taking soil samples and having these examined in a laboratory. However, this method is labour-intensive and requires transport as well as the availability of a laboratory.

Eijkelkamp Agrisearch equipment has developed a probe which enables its user to determine the salinity of a soil electrically. This probe is called the EC-probe (Electrical Conductivity).

In combination with an earth resistivity meter, the resistivity of the soil is measured, and this reading is subsequently converted into electrical conductivity. This conductivity depends on the structure and texture of the soil, the moisture content and the salinity of the ground water.

The method is less accurate than a soil sample analysis in a laboratory set-up, but for an estimate of the salinity this method is highly satisfactory. When one has sufficient reference samples, the EC-probe can be used to perform many compa-rative measurements in a certain area in a short period of time.

The EC-probe consist of a stainless steel bar, provided with a detachable handle. The bar is provided with a 10 cm graduation. Inside the actual probe, at the bottom of the bar, there are four electrodes, separated by a sealing ring and a insulation ring.

To facilitate measurements with the EC-probe, proper contact (= low contact resistance) with the surrounding soil is necessary.

To establish proper contact, first the gouge auger is used to make a pilot hole to the desired depth. The drilled out soil can be used as a reference sample to determine the calibration curve.

In every EC-measurement, the temperature of the soil stratum that is to be read must also be measured. For this purpose, the tip of the probe is provided with a temperature sensor. Having measured the earth resistivity, the temperature correction factor is determined.The temperature coefficient can be read before the electrical conductivity is calculated.

Availability

The standard set inlcudes: the EC-probe, an earthresistivity meter, the single gouge auger, a spatula and a strong transport bag.

  • Operates quickly and easy.
  • Saves labour and laboratory research
  • Is relatively inexpensive compared with laboratory research.
  • Eart resistivity meter comes in splashproof, shockresistant synthetic housing.

Remarks

  • One limitation is that the research method is less accurate tha a soil sample analysis in a laboratory setup (however, it is much faster).

Maximum measuring depth: < 100 cm
Measured parameters: conductivity, temperature
Measuring accuracy: 0.05 mS/cm
Measuring principles: direct electrical (bulk soil) conductivity + temp.
Measuring range: 0.01 - 20 mS/cm, 0 - 2000 Ohm
Reading accuracy: 1 Ohm
Registration type: manual
Package size: 117 x 27 x 23 cm
Volume of material needed: 80 ml ml
Weight: 7 kg

Irrigation research
pH / EC / Redox measurement

Customer reviews

No reviews were found for Model 14.01 - EC-Probe for Soil Salinity Measurements. Be the first to review!