Turbo Controls

- Model DC Series - Sequencer for Dedusting Plants with Digital DP Control

From

0

Sequencer for dedusting plant cleaning cycle control with digital dP control by mtemai transducer. Device with microprocessor management and zero-crossing detection for the outputs activation to give high immunity from external interference and low fieW emission. Max 3 output relays. Max 3 digital voltfree input.

  • Standard supply voltage : 230 VAC/115 VAC
  • Supply voltage on request : 24 VAC / 24 VDC
  • Output voltage : 230 VAC M15 VAC/24 VAC/24 VDC
  • Operating temperature : -10C + *50C
  • Power requirement : 10 VA (Standby)
  • Protection degree : IP65
  • No. Outputs : 16
  • Dimensions : 240x185x114 mm./IP65

  • Minimum and maximum dP alarms on same relay (K2)
  • Relay Voltage ON (K1)
  • Select Number of outputs
  • Activation time from 0.05 to 5.00 sec.
  • Interval time from 1 to 999 sec.
  • Interval time between ev. during post-cleaning
  • Short-circuit protection of every single output
  • Manual activation of every single output from keyboard
  • Digital differential pressure control (STOP at cycle end)
  • Cleaning cycle
  • dP zero readout regulation
  • Minimum dP alarm. Contact open with alarm. Automatic reset.
  • Maximum dP alarm. Contact open with alarm. Automatic reset.
  • dP full range lOkPa
  • Additional post-cleaning cycles from dP readout. Activation at STOP.
  • Consent from external compressed air pressure switch
  • ON/OFF cleaning cycle from external contact
  • Operation hours-counter
  • 6x4 RILSAN air connections
  • Maximum load power 25W per output
  • Input and output voltage selection
  • Multi language display

Customer reviews

No reviews were found for Turbo - Model DC Series - Sequencer for Dedusting Plants with Digital DP Control. Be the first to review!