SnapNrack PV Mounting System

SnapNrack Rail Cutting Tool 01-Video

0

This tool is a great time saver for installations with SnapNrack's universal end clamps. It allows you to install the array without being overly precise about where the ends of the rails are located, leaving some rail hanging out of the array edges. But then when it's all done, you can come back and trim them back to be flush with the array without scratching the module frames, using a standard saw-zall type saw. This is shown on a composition roof on flashed L feet, the lowest possible placement of the array to the roof surface. Installation on other roof surfaces or ground mounts (the tool also works with our ground rail) will have a lot more room under the tool to work with.

Customer comments

No comments were found for SnapNrack Rail Cutting Tool 01-Video. Be the first to comment!