The Crunch Factor – Corn Chip Edition
Friday, January 29 was National Corn Chip Day. To celebrate, we took a closer look at this wonder of the snack world and are sharing the important role that moisture plays in the production of corn chips and snack foods in general. To get the scoop on corn chips, we spoke to Randy Rupprecht, QA Manager, and Mike Klein, Processing Manager, of Axium Foods.
Every snack food has its own set of optimal conditions that will produce the perfect pretzel, crisp or chip. What is considered too much moisture for one might be the perfect amount for another, which is why it is essential for producers of snack foods to monitor the moisture content of their products. Doing so not only improves the consistency and quality of the products, but can also reduce waste and help optimize production.
Back to Corn Chip Basics
To make a corn chip or a tortilla chip, you start by cooking the corn in a lime/water mixture. Adding lime to the water, Mike explains, improves water absorption and helps remove the outer pericarp of the corn so that the final product is crispier. It also helps increase shelf life by controlling microbial growth.
After cooking, the corn is then left to soak for several hours. Soaking helps disintegrate what remains of the outer hull of the corn and, Mike adds, “allows the moisture to reach the entire kernel and equilibrate the moisture level at 51-52% to produce the best corn chips.” The water is later replaced by oil in the frying process, which decreases the moisture content and increases the crunch factor of the final product.
After a good, long soak and a nice shower to remove excess lime and pericarp, the corn is sent to the mill where it is ground into masa dough. It is at this point that an initial moisture check is performed.
For the ‘work in process test,’ Randy looks for roughly 50% moisture in the dough. If the moisture reading is slightly higher or lower than desired, adjustments can be made to raise or lower the moisture level as needed. Once the masa is determined to have a moisture content within the desired range, it is ready for the extrusion process. The dough is pushed through a die to form the shape of the chip. Different dies can be used to create differently shaped chips. A cutting tool slices the dough strips at the proper length and the chip continues on its journey.
This is where a major difference between corn chips and tortilla chips comes into play. While tortilla chips are sent first to the oven then to the fryer, corn chips are sent directly to the fryer. Randy explains the difference like this:
Tortilla chips are baked prior to frying in order to decrease the moisture content in the chip so that, when it is fried, there will be less water available to be replaced by oil, giving the tortilla chip a softer crunch compared to a corn chip. The more moisture available prior to frying, the longer the chips can be in the fryer and the crunchier the final product will be.
“We aim for between .6% and 1.1% moisture for our corn chips and between .8% and 1.6% for our tortilla chips,” Randy says. Moisture testing is performed every hour using a Computrac® MAX 4000XL to ensure that every batch of chips meets Axium Foods’ high quality standards. Axium also uses the Computrac to calibrate a number of inline sensors they use to provide real time trend data to the operator and supplement the testing done in the quality lab.
After spending some time in the fryers, the corn chips are seasoned, salted, packaged and on their way to consumers. After all, how are we supposed to celebrate holidays like National Corn Chip Day without indulging in a handful or two of the tasty, crunchy treat.
-
Most popular related searches
Customer comments
No comments were found for The Crunch Factor – Corn Chip Edition. Be the first to comment!