Agricontrol Srl products

The µAgricomp System is a distributed climate control system where each greenhouse compartment is controlled by a climate computer.

The µAgricomp Multitab is an enhanced version of the µAgricomp System. The main characteristic is the possibility to divide the 24 hours day in up to 6 periods where all the set-points of the control functions can be programmed in a different way. Every period has its own independent programming table. The starting time of each period can be set as an absolute clock hour or as a number of hours and minutes before/after the sunrise or the sunset.

If the number of control functions of the greenhouses is limited to top vents, side vents, on/off heating, screens/shading and circulation fans or a subset of these, it is possible to use the MCX series of Multicompartment Climate Control Computers.

C-SPORT : Vents opening proportional to temperature. Six models: from 1 to 6 independent compartments controlled at the same time. Wind speed and rain control with limited programmable vents opening, if required by temperature. Total closing for storm. The WPR models control also the On/off Heating. The WPG models control also the inflation of the double film greenhouse cover.

X-IP : Small Irrigation programmers for 2 valves+pump or 3 valves. For every valve programmable time in minutes and seconds. 4 irrigation programs. 5 daily start times per program. Cyclic irrigation: programmable pause between two cycles. Water budget. It does not lose time and programs in absence of power.

INTS-01 : When the light sum reaches a programmed value, a relay is closed to activate a pump or an irrigation valve for a programmable time in minutes and seconds. When the number of valves is more than one, the controller can be connected to an Agricontrol irrigation programmer (IP-xx) to start an irrigation program.

24 irrigation programs. In every program until 32 groups of valves. Each group can contain from one to six valves that are operated at the same time. The groups of valves are activated in sequence, everyone with its programmable time or volume of irrigation (in litres if a litres counter is connected, in this case a control of the effective opening of the valves is possible). An event table allows to record the power-up and power-down times and eventual not opened or not closed valves. The sequence of the valves is free. A program can be activated or at 5 different daily times or cyclically with fixed pause or in function of the light sum. A program can be linked to others: at the end of a program another program  can be activated.

The  fertigation system AGRIMIX-L allows the automatic mixing  from 2 (AGRIMIX-L2) to 6 (AGRIMIX-L6) mother solutions (A, B, C, D, E and F)  and an acid solution for pH control, to form and distribute to the crop the desired fertilizing solution.

The fertigation system AGRIMIX-L2K (-L3K) allows the automatic mixing of 2 (3) mother solutions (A, B,(C)) and an acid solution for pH control, to form and distribute to the crop a fertilizing solution. The machine is controlled by a very easy to use, but powerful computer. Although conceived as an entry level low cost machine, it allows a very precise and reliable fertigation management.