Dairy Feed Kitchen System - Brochure

Data sheet: Straw conveyer – BT 170 november 27, 2013 I:\\1-Dok\\Salg\\Maskindata\\WWW\\DS_BT 170 Bale conveyer_2013_UK.doc Picture Machine function Receiver and conveying table made with chain and slat for filling into a bale breaker, straw shredder or other device. The min. length is 5 meter, on special demand shorter down to 2,5 meter and can be extended to max. length of 10 me-ter with 2.5 meter sections. Machine number for standard 1013-454 (5m), 1013.455 (7,5 m), 1013-456 (10m) Machine paint: Machines, guards etc. comes in a color type RAL 3001 red suitable for indoor, non corrosive environment - water and oil resistant -15 to + 60 degrees C, surface purified with alkaline degreaser, painted with a machine primer and here after coating paint. Custom tariff number 84369900 Power consumption kW 2,2 kW Measures W=1800 mm, H=850 mm and L=5000, 7500 or 10000 mm Weight 500 kg up to 1000 kg Standard DS/EN 60204-1:2006 Safety of Machinery - Electrical Equipment of Machines, DS/EN ISO 13850 of January 29th 2007 emergency stop, DS/EN ISO 13849-1 safety-related parts of control systems, DS/EN 60204-1: 2006, cable in-stallation method E RISK ASSESMENT - Machine The machine can be used as a “stand alone” machine and is therefore also delivered with a CE marking and conformity declaration. Emergency stop wire is placed along both sides of the ma-chine. There is no risk for dust explosion inside the machine. Safety level as stand alone: PLr: a (EN/ISO 13849-1) Safety level with MTX_H or RBS PLr: c (EN/ISO 13849-1) EXTRA equipment: - Weighing load cells 2 per section, min 4, max 8 incl. machine feet. - Special fit legs with reduc-tion of load cell and ma-chine feet height. - Junction box to connect load cells. - Signal amplifier 24 Volt Data sheet: Straw conveyer – BT 170 november 27, 2013 I:\\1-Dok\\Salg\\Maskindata\\WWW\\DS_BT 170 Bale conveyer_2013_UK.doc Analyzed risk following EN-ISO 13849-1: S F P PLr 1. Mounting: The machine is provided lifting positions that ensures balance when lifting and strong enough to hold machine load. Work place assessment should be made, before start with mounting. S2 F1 P1 c 2. Operating: If a person sticks he’s hand into the machine where the chain slat is going under the table, then he’s finders can get squeezed while the slat is passing, after passing he can pull he’s fingers again. On both sides of the machine is placed a emergency wire to be pulled in case of incident. S1 F1 P1 a 3. Servicing: All lubrication positions are from safe position, tightening of chain is from safe position. S1 F1 P1 a 4. Renovation: When changing slats or chain, no accidental start of machine should be possible, the machine must be turned off on the main switch and locked. S2 F1 P1 c 5. Scrapping/recycling: same comment as under 1. Mounting S2 F1 P1 c