- Home
- Equipment
Refine by
Cable Arm Agricultural Equipment & Supplies
9 equipment items found
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
To prevent material from being spilled, the sides of our environmental clamshells are equipped with strong rubber seals. These seals form a tight bond when the clamshell is raised that material cannot ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
Cable Arm Environmental clamshells remove material at almost the same water content and volume as in-situ materials. Excess clean water in the clamshell is drained through vents located above the sediment water interface. The passive venting system also minimizes downward pressure, seals in material, and prevents water from washing contaminated sediment out of the ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
In environmental dredging, it is essential to remove contaminated sediment in a uniform fashion. Cable Arm's patented Level-Cut footprint makes this possible. As the clamshell closes, the edges draw together and the pivot point lifts, leaving a large rectangular footprint that is near level. Each successive bite overlaps the previous to ensure complete sediment ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
Cable Arm clamshells are designed with an over-square footprint. Typical bucket designs consist of an open length that is larger than the bucket width. A Cable Arm bucket is designed with the width greater than the open length. This design provides a wide array of benefits. Due to the extra large surface area covered, they are the leading buckets for shallow face ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
Overlapping Side Plates are a key design feature. The plates are designed to stop the windrowing of material from pushing out the opening of the sides of the bucket while ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
The T-Link design seperates the level-cut feature from the bucket arm. By making the level-cut independent of the closing force, a lighter bucket with a greater digging force was produced- increasing the productivity and allowing for more sediment removal per cable size. ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
The material's center of mass is located below the center of the bucket’s containment area, minimizing material washout during bucket closing and ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
The angle of the cutting edge defines the quality of the footprint left behind. Typical buckets have a sharp angle that push and compact material instead of cutting through it. The Cable Arm angle allows the bucket to “scoop” material while also lowering the materials center of mass within the containment ...
Manufactured by:Cable Arm, Inc based inTrenton, MICHIGAN (USA)
The ability to rotate 360° is imperative on an excavator. Cable Arm makes certain that each bucket manufactured has a full range of motion available. TAPER/SLOPING PROFILE – allows for angled, lateral movement along an inclined bottom. Previously, over dredging in ‘steps’ and additional capping were required. (angle up to ...