Tetramethylthiuram disulfide is a widely used pesticide and a soil treatment agent in the agricultural sector. Consequently, its detection in the environment and investigation of the distribution between the aqueous and soil phases would be of highly importance. In this study, the detection of tetramethylthiuram disulfide in CHCl3 was successfully achieved through absorbance measurements at 280 nm, which resulted in linear calibration curves. This detection method was extended for the determination of the partition coefficient (KD) of tetramethylthiuram disulfide between CHCl3 and H2O phases at ambient temperature. The partition coefficient was subsequently used to determine the apparent partition coefficient (KD) of tetramethylthiuram disulfide between sieved soil of diamater < 2.0 mm used for agricultural practices and water where by the quantification of tetramethylthiuram disulfide in water after adsorption equilibrium with soil was achieved through a solvent extraction step of tetramethylthiuram disulfide-contaminated water into CHCl3. The KD determined for an initial tetramethylthiuram disulfide concentration ranging from 3.00 ppm to 10.00 ppm showed a decreasing trend, which leveled off at high concentrations, indicating the strong irreversible adsorption behavior of tetramethylthiuram disulfide on soil at low concentrations. The proposed detection method would have the potential to determine the extent of adsorption of tetramethylthiuram disulfide in soil or its levels in water when tetramethylthiuram disulfide is introduced to soil systems for agricultural practices.