Talex OptiCut - Model 250 - Z302/1 -Rear-Mount Disc Mower

BLADE QUICK-CHANGE SYSTEM

• allows for fast and easy replacement of blades
• OVERRUN SAFETY GUARD
• If an obstacle is hit, the cutting unit is tilted backwards by 15 degrees

HYDRAULIC CYLINDER

• Facilitates manoeuvring and transport of the machine

SPRING RELIEF SYSTEM

• Springs relieve the pressure of the cutter bar on the ground thus extending its life

LIFTING FRONT PART OF THE GUARD

• Greatly facilitates access to the cutter bar if it is necessary to replace a cutting blade or a bearing

COMER CUTTER BAR WITH A DISC SAFETY DEVICE

• Each disc is protected by a defined crack point. Upon hitting an object (eg. stone), only one disc is disabled from the drive system, rather than the whole bar. Significantly lowers repair costs and failures.

BLADE HOLDERS

• Made out of hardened boron steel

BELT TRANSMISSION

• Drive is transmitted via four V-belts

EASY BACK TURNING MECHANISM

• Enables manoeuvring above swath rows

PROTECTIVE TARPAULINS

• Additionally reinforced along the bottom edge with a rubber collar

TERRAIN COPYING SYSTEM

• 0–8 degrees working range of the cutter bar

THREE-POINT HITCH

• made of tough, thick-walled profile
• extra-reinforced with braces, cat. II and III suspension

STANDARD EQUIPMENT:

460nm PTO shaft with one-way clutch, protective tarpaulin, mechanical safety guard, hydraulic cylinder, adjustable support leg, transport lock, central holder, blade quick-change spanner, set of additional cutting blades

ACCESSORIES:

• SWATH WHEELS
• HARDENED SKID PADS PREVENTING EXCESSIVE WEAR

• Model: Z302/1
• Disc/blade quantity: 6/12 (6 left + 6 right)
• Min. power requirement: 45HP
• Weight: 527kg
• Working width: 2.5m
• Working efficiency: ~2.5 ha/h
• PTO: 460Nm L=860; 540 RPM
• 3-point hitch category: II/III
• Number of V-belts: 4