Irrigation Line Equipment In Australasia
-
PremiumManufactured by Atlantis International Corporation Pty Ltd.based in AUSTRALIA
enables designers and users to install vertical gardens in adverse outdoor environmental conditions and in regulated indoor environments with complete access and control. The new enhancements provide targeted watering control of individual plants, maximum water efficiency, last minute design changes and easy access to irrigation components. ...
-
Manufactured by K-Line Irrigationbased in USA
K-Line offers a choice of 5 NAAN durable sprinklers with application rates of 2.04 to 5.11 gpm and operating pressures of 35-55 psi. To connect to the tapping saddle choose the ...
-
Manufactured by K-Line Irrigationbased in USA
K-Line tapping saddles are available in 3 sizes:- 32mm (black), 40mm (green) and 45mm (black). The choice is determined by your choice of pipe. ...
-
Manufactured by K-Line Irrigationbased in USA
K-Line Irrigation's New 4 Pod 1.5 acre kit is designed for the homeowner with a large garden or backyard parcel to irrigate. The kit comes with 4 tan colored pods, 250 feet of 32mm (approximate 1 1/4") tubing, and all the parts and components required to hook up to an 1 1/4" water supply. The manual includes an inside page of all ...
-
Manufactured by Tavlit Plastic Ltd.based in ISRAEL
For over 25 years TAVLIT has been supplying high quality drip line valves. Drip Line valves enable quick and easy isolation of drip lines for repair and when the specific line is not irrigating. The tape line valves expands the wide range TAVLIT offers with products specifically designed to the ...
-
Manufactured by Mottech Water Solutions LTD.based in ISRAEL
Mottech by-pass fertigation machine designed to inject fertilizers and acid into the irrigation water. The fertigation machine locates in parallel to the main irrigation line and injects the nutrients and acid using venture pumps with fertilizers meters and under monitoring of EC and pH sensors. The IRRInet & ICC PRO system ...
-
Manufactured by K-Line Irrigationbased in USA
The K-Line G-Set Pod Irrigation system consists of a low maintenance solar rechargable battery powered controller that operates low power latch coils that in turn operate a 40mm valve. Two controllers are available, a set it and forget it independent controller, and a mesh controller that can be radio updated from a distance. Both ...
-
Manufactured by The Toro Companybased in USA
In line with their commitment to providing specialised products for the specific needs and purposes of their consumers, Toro Ag Irrigations have developed a line of overhead mini sprinklers suited to agricultural row crops, nurseries, hothouses and even evaporative cooling in poultry ...
-
Manufactured by ECOsmarte Planet Friendly, Inc.based in USA
The system pictured will handle the 2 acres plus a 6000 square foot, 6 Bath house.Whether you're a consumer gardener or a commercial grower/rancher, ECOsmarte’s irrigation product line and eighteen year field experience will achieve better results with less water used. Soil moisture levels rise with the oxygenated and ionized water. In ...
-
based in GERMANY
Reichhardt GPS guidance makes it possible to steer a vehicle with accuracy by the aid of GPS navigating signals. You chose the accuracy you need for your application for your farm. Reichhardt GPS guidance is capable of reading GPS Serial (NMEA-0183) or CAN (NMEA-2000) message formats, which are used by the majority of receivers on the market. This allows the use of many different brands of ...
-
Manufactured by Valley Irrigationbased in USA
Similar to the Valley Benders, our DropSpan option can increase your irrigated acres without purchasing more land. With the DropSpan, you can drop the outer spans of your center pivot or linear, so the rest of your machine can irrigate acres behind barriers at the edges of the field. DropSpan allows you to drop as many spans as ...
-
Manufactured by Mottech Water Solutions LTD.based in ISRAEL
Mottech Irrigation Decoder system utilizes a single pair of wires to operate multiple stations with individual decoders connected along a 2-wire cable. Each decoder contains a microprocessor which receives 24VAC power supply and control signals along the 2-wire line directly from the IRRInet ACE controller.The decoders are ...
-
Manufactured by K-Line Irrigationbased in USA
The tough one piece rotary molded K-Line pods which house the sprinklers are made of very strong impact and abrasion resistant UV-protected polyethylene that should last for years. The heavy duty skid plate on the bottom gives the pod a low center of gravity. The heavy duty construction is designed to withstand the rigors of being pulled ...
-
Manufactured by K-Line Irrigationbased in USA
A choice of 5 Nelson nozzles allows for varied application rates of 1.64-5.47 gpm at 45-60 psi. The Nelson sprinkler is available with pressure compensating sprinklers which results in very good uniformity in hilly applications. This is a highly dependable rotary style sprinkler made from heavy duty plastics. The key fact about the Windfighter is that it can accomplish greater uniformity in ...
-
Manufactured by K-Line Irrigationbased in USA
The specially formulated polyethylene tubing is the key component to the system. This tubing is made of linear low density polyethylene resins that make it very strong yet flexible when used in the K-Line system. This tubing can withstand the effects of abrasive soils, kinking, freezing, the damage from UV light, and the various stresses ...
-
Manufactured by K-Line Irrigationbased in USA
A choice of 5 Nelson nozzles allows for varied application rates of 1.64-5.47 gpm at 45-60 psi. The Nelson sprinkler is available with pressure compensating sprinklers which results in very good uniformity in hilly applications. This is a highly dependable rotary style sprinkler made from heavy duty plastics. The key fact about the Windfighter is that it can accomplish greater uniformity in ...
-
Manufactured by K-Line Irrigationbased in USA
The R33 Rotator is an innovation that saves money, saves time, and performs better than the 3/4” brass impact sprinklers it’s designed to replace. The R33 uses Nelson’s proven Rotator® technology to provide longer throw distance, fight the wind and deliver uniform coverage. While brass sprinklers are prone to damage, clogging, and theft, the R33 is easy to clean, easy to ...
-
Manufactured by Tavlit Plastic Ltd.based in ISRAEL
For over 25 years TAVLIT has been supplying high quality drip line valves. Drip Line valves enable quick and easy isolation of drip lines for repair and when the specific line is not ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you