Irrigation Equipment Near Zaire
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture sensor Thetaprobe ML3. Measuring range 0-50% vol. Accuracy +/- 1%. With 4 pins, length 60 mm, Ø 3.2 mm. Output signal 0-1 Vdc. Inclusive temperature meter range -20...+60 °C, accuracy +/- 0.5 °C over 0...40 °C. Exclusive cable. Warranty 5 ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The quick draw tensiometer is a small tensiometer that can easily be moved and, using the auger for pre-drilling, placed into the soil. The small diameter and the super porous ceramic cup and the possibility of pre-setting the tension, allow a measuring period of only a few minutes. After each measurement the tensiometer can be stored in a carrier cylinder in which it is kept humid allowing ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Also included in our product range is the WET sensor, to measure pore water conductivity and temperature in the top layer of a soil. The measurement values are shown on the display of the hand held meter and can be stored in the memory (including time and sensor location). These data can be read on a ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Soil moisture sensors that measure the moisture tension in the soil are read out with the soil moisture meter Watermark. The measuring principle is similar to that of the gypsum block system. The special sensors however do not dissolve in the soil and have a more consistent distribution of pores so that more accurate measurements are ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Tensiometer set. Complete standard set for multiple measurements to a depth of 90 ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The Jet-fill tensiometer basically has the same components as the standard tensiometer but is equipped with a reservoir and a refill mechanism. At a push of the button the Jet-fill mechanism instantly injects water from the reservoir into the body of the tensiometer and removes accumulated air. This tensiometer can be provided in different lengths as ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The standard tensiometer consists of a clear transparent plastic tube with a ceramic cup at the bottom end and a manometer at the top. The standard tensiometer is delivered in various lengths allowing the execution of simultaneous measurements at various depths in the root zone. For pre-drilling special auger sets can be ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
EC-probe for soil salinity measurements, standard set for measurements to 1 m ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Set for pF determination with ceramic plates, minimal standard set, (0.1...15 bars of ...
-
based in UGANDA
this is a very good product . Flow rate :14.4m3/hr maximum radius of cover :42m pressure requirement ...
-
Manufactured by bhumi polymers pvt.ltdbased in INDIA
I would like to give a brief introduction of our Company BHUMI POLYMERS PVT. LTD. is Fast Growing Company of India in Micro irrigation Sector. We are leading manufacturer of Drip irrigation system, Mini sprinkler irrigation system, Sprinkler Irrigation System and Green House. We are also work with various State Government in India Under Subsidy Scheme like GGRCL-Gujarat, MPDAGE-MP, APMIP-AP, ...
-
Manufactured by Hach - Veraltobased in USA
Soil and Irrigation Water Test Kit - Model SIW-1: A test kit for professional scientists and non-scientists alike, the SIW-1 Soil and Irrigation Water Test Kit is ideal for fertility analysis, site characterization, and irrigation water quality assessment under a wide variety of conditions. Farmers, researchers, extension agents, and educators can use the versatile test kit at remote sites, in ...
-
Manufactured by Genap B.V.based in NETHERLANDS
During storage, water becomes contaminated with algae which results in irrigation systems becoming blocked and all of the consequences that entails. Genap has a number of solutions for this in its product range. These cover systems are an appropriate solution for combating algae growth, they also prevent evaporation and to a large extent they prevent contamination of the ...
-
Manufactured by Genap B.V.based in NETHERLANDS
During storage, water becomes contaminated with algae which results in irrigation systems becoming blocked and all of the consequences that entails. Genap has a number of solutions for this in its product range. These cover systems are an appropriate solution for combating algae growth, they also prevent evaporation and to a large extent they prevent contamination of the ...
-
Manufactured by Agro Irrigation & Pump Services Limitedbased in KENYA
As an ever expanding company with the main focus on providing affordable solutions to the farmers Agro Irrigation has set up a plastics division and is currently producing high quality pipes. We have full technical back-up from our principals in Israel which gives us confidence to assure the client of a world class product at an affordable ...
-
Manufactured by Agro Irrigation & Pump Services Limitedbased in KENYA
Agro Irrigation is one of Kenya's leading pump suppliers. No matter for which purpose an efficient and energy saving pump solution is required; agro Irrigation offers a high-quality solution. We have partnered with leading pump suppliers raining from Centrifugal pumps for industry, water supply, waste water and dosing, Circulator pumps for heating and air conditioning. To Agro Irrigation, the ...
-
based in USA
Airex DC™ is a liquid co-polymer with ammonium sulfate and is proven to be highly effective in controlling spray-drift. It can be successfully used for control of spray-drift in aerial or ground spray applications of water emulsifiable pesticides, herbicides and plant growth regulators (PGR). The properties of Airex DC™ allows the application of chemicals to be uniform without particle or vapor ...
-
based in USA
TeraGel (T-200)� water crystals absorb and hold hundreds of times their weight in water and then upon demand release the moisture to the plant. Of all plant polymers now ...
-
based in USA
AgraGel (T-500) is a soil polymer specifically formulated without polyacrylamide to comply with regulations in countries that require acrylamide free soil amendments. AgraGel (T-500) crystals absorb and hold hundreds of times their weight in water, and then upon demand, release the moisture to the plant. Of all plant polymers now available, AgraGel® (T-500) crystals have the greatest ...
-
based in USA
TeraFlo AG is an environmentally friendly polymeric formulation providing a variety of benefits when any type plant, grass or trees. The viscous liquid copolymer base contains humectants, sulfates and proprietary additives that have specific applications for Fine Turf, Horticulture, Landscaping, Tree Orchards and ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you